5 Series E39 540i (M62) SAL
Drive in radial seal (1) for selector shaft with special tool
23 2 260 .
Secure selector shaft with special tool 23 2 270 in neutral
position.
Use a 8 mm bolt and cylindrical pin (2) from the shift joint or a
suitable mandrel for holding the shift shaft.
Clean front housing section.
Drive out sealing cap (3) for locking pin with a mandrel from inside
to outside.
Installation:
Replace sealing cap.
Replace bearing of drive shaft and retaining segments (1).
Remove retaining plates (1).
RA Removing and installing complete drive and output shafts (S5D 260Z / 310Z / 320Z
BMW AG - TIS
20.02.2013 14:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 13 -