5 Series E39 540i (M62) SAL
Caution!
Do not let propeller shaft fall into joints.
Joints and rubber sleeve can be damaged on constant-
velocity joint.
Bend propeller shaft downwards at center bearing, remove from
transmission output flange and tie up to one side with a thread or
wire.
Unlock cable connector and remove.
Unclip cable from transmission case.
Unlock and remove cable connector (1).
Pull cable connector (2) off impulse sensor.
Caution!
If the pulse generator is converted to a new transmission, the
pulse generator must be readjusted,
refer to 12 14 520.
RA Removing and installing automatic transmission (A5S 440Z)
BMW AG - TIS
20.02.2013 14:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
