5 Series E39 540i (M62) SAL
Caution!
Only unfasten control arm on swivel bearing since otherwise a
wheel alignment check is necessary.
Press control arm off swivel bearing with special tool 31 2 240.
Installation:
Tapered spigot and bore both free of grease.
Use corrugated washers.
Replace self-locking nut.
Tightening Torque, if necessary brace on hex cap nut,
refer to Technical Data 31 12 6AZ.
Attach workshop hoist with special tool 31 2 220 and front axle
support.
Unscrew left and right bolts and remove front-axle carrier.
Installation:
Front screw M12 X 107.
Tightening Torque,
refer to Technical Data 31 10 1AZ.
RA Removing and installing/replacing front stabilizer (high)
BMW AG - TIS
20.02.2013 15:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -