bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

18 Exhaust System (M62) > < 1 SI Coolant Level In Expansion Tank E53 E38 E39 M62, M62 LEV
Page 2
background image

Check control message "Check coolant water level" (permanent display), coolant level in
expansion tank too low:

Check cooling system for coolant leakage - please refer to Repair Instructions, job
item 17 00 009 .

Check coolant level on cold engine - please refer to Repair Instructions, job item 
17 00 039 .

The coolant temperature must not exceed 30 

°

C. If the ambient temperature is greater

than 30 

°

C, allow the engine to cool down to the ambient temperature.

Black expansion tank:

Top up the coolant until the upper end of the red float rod is at the same level as the
upper edge of the expansion tank filler neck (see logo on expansion tank: Max. level =
reference level).

Check control message "Check coolant water level" (intermittent display)

Examinations have shown that coolant level switches exchanged in this situation work
without faults.

The coolant level must be checked with the engine cold.

If the coolant level is too low:

Check the cooling system for coolant leakage and top up with coolant.

Coolant traces on expansion tank cap and on expansion tank:

As a rule, the pressure relief valve in the expansion tank cap will as a matter of
function
 have released pressure due to the cooling system being overfilled.

The expansion tank cap must not be replaced without being checked!

A new special tool (adapter for handpump, no. 17 0 008) has been developed and a
new procedure specified for checking the pressure release valve in the expansion tank
cap - please refer to Repair Instructions, job item 17 00 009 .

Note:
The adapter was revised in July 1997 (new adapter = no. 17 0 007). 
The old adapter, no. 17 0 006 must no longer be used and should be scrapped. 

Only replace the expansion tank cap if it can be shown to be defective.

It is imperative that the traces of coolant on the expansion tank cap and on the
expansion tank itself are removed!

SI  Coolant level in expansion tank E53 E38 E39 M62, M62 LEV

BMW AG - TIS

20.02.2013  09:33

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

18 Exhaust System (M62) > < 1 SI Coolant Level In Expansion Tank E53 E38 E39 M62, M62 LEV