5 Series E39 540i (M62) TOUR
Turn engine on central screw counter-enginewise up to 45
°
before
TDC position.
Note markings!
Release cylinder-head bolts in sequence 10 ... 1.
Lift off cylinder head.
Installation
Installation of cylinder head is described separately from removal.
Assembly sequence for removal and installation is different.
Clean sealing faces of cylinder head and engine block, if
necessary using wooden scraper to remove gasket debris. Ensure
that no gasket debris drops into the oil and coolant ducts.
Threaded bores in engine block must be free of dirt and oil
(danger of cracking).
Coat joint between engine block and timing case cover with
Drei Bond 1209 (refer to BMW Parts Service).
RA Removing and installing right cylinder head (M62 up to 9/98)
BMW AG - TIS
20.02.2013 12:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
