5 Series E39 540i (M62) TOUR
Installation:
Keep sealing faces clean and free of oil.
Apply coat of Drei Bond 1209 to joint between cylinder head
and lower timing case cover (refer to BMW Parts Service).
Seat new rubber seal in groove.
Installation:
Ensure that seals are correctly seated.
Press bow cover inwards and fit timing case cover.
Install screws (1) and fit flush with cylinder head.
Installation:
Remove outer and inner gasket from cylinder head cover.
Insert special tool 11 6 431 from special tool kit 11 6 430
in groove of cover and fit cylinder head cover.
RA Removing and installing timing case cover, top right (M62 VANOS from 9/98)
BMW AG - TIS
20.02.2013 12:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
