5 Series E39 540i (M62) TOUR
Caution!
Left-hand threads.
Tighten screw connection (2) of inlet camshaft on cylinder
bank 5 to 8 to an initial torque of 15 Nm and then slacken off
again by a 1/4 turn.
Caution!
Left-hand threads.
Tighten screw connection (1) of exhaust camshaft on cylinder
bank 5 to 8 to an initial torque of 15 Nm and then slacken off
again by a 1/4 turn.
Note:
The continuity test with the multimeter described in the following is
not possible on the M62 B46 because of the different design of
the camshaft adjustment unit.
The remaining procedure is identical.
Connect a commercially available multimeter to a contact pin on
camshaft adjustment unit and to the screw connection on oil line
on cylinder bank 1 to 4.
Set multimeter to acoustic continuity test.
RA Removing and installing/replacing right camshaft adjustment unit (M62 VANOS from
BMW AG - TIS
20.02.2013 13:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
