5 Series E39 540i (M62) TOUR
11 78 533
Replacing Lambda control sensor, right (M62)
(Refer to operation no. 13 00 002)
Read out fault memory, clear if necessary.
Unclip Lambda control sensor cable from retainer.
Disconnect plug connection for Lambda control sensor.
Release Lambda control sensor with special tool 11 7 030.
Installation:
The threads of new oxygen sensors are already coated with
Never Seez Compound.
If an oxygen sensor is used again, apply a thin and even coat
of Never Seez Compound (refer to BMW Parts Service)
to the thread only.
Do not clean the oxygen sensor section which protrudes into
the exhaust line and ensure that it avoids all contact with
lubricants.
Installation:
Secure Lambda control sensor with special tool 11 7 030.
Tightening Torque,
refer to Technical Data 11 78 1AZ
Pay attention to cable routing of Lambda control sensor.
RA Replacing Lambda control sensor, right (M62)
BMW AG - TIS
20.02.2013 13:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
