5 Series E39 540i (M62) TOUR
Safe stopping in an open position is assured in an opening angle range of 30
°
to 90
°
. This is achieved by a
minimum system pressure of 40 bar (determined by the emergency valve).
Checking fluid level in hydraulic unit:
Caution!
In the event of fluid loss, the hydraulic unit must be replaced if
the fluid is below the marking because damage to the unit
cannot be excluded.
Hydraulic unit together with cylinder and lines must be
replaced:
If, in the event of rear end damage, the spare wheel recess is
defective and the line connections are bent.
Remove luggage compartment floor trim panel.
Test conditions:
Open trunk lid (by motor) once and then close again so as to
bleed the system.
Open trunk lid again (by motor).
Unscrew nuts (1).
Remove car jack (2) and wedge (3).
Unscrew nuts (1).
Remove storage tray (2).
Remove spare wheel (3).
Unfasten plug connection (1).
Loosen screw (2).
Unscrew nuts (3).
RA Instructions for automatic rear lid actuation (electrohydraulic/fully automatic)
BMW AG - TIS
20.02.2013 21:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
