5 Series E39 M5 (S62) SAL
11 12 106
Removing and installing right cylinder head
(S62)
Special tools required:
•
00 9 120
•
11 2 250
•
11 2 300
•
11 7 120
•
11 7 130
•
11 7 150
•
11 7 200
•
12 6 050
•
12 6 410
•
12 6 411
(cylinder bank 1 to 4)
Remove right exhaust manifold.
Open drain plug on radiator. Open drain plug for coolant on right
and left sides of engine block. Drain and dispose of coolant.
Installation:
Replace sealing rings for drain plugs on engine block.
Tightening torque, refer to 11 11 5AZ .
Top up coolant. Vent cooling system and check for leaks.
Remove right intake filter housing with air-mass flow sensor.
Remove intake air manifold.
Detach engine wiring harness section from both cylinder heads
and lay to one side.
The procedure is described in the work step Replacing wiring
harness section for motor.
RA Removing and installing right cylinder head (S62)
BMW AG - TIS
21.02.2013 06:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -