5 Series E39 M5 (S62) SAL
Install engine in special tool 00 1 450 .
Snap locking pin (1) into place.
Close locking detent (2) on right and left and screw down.
Remove both cylinder head covers.
Remove all spark plugs.
Remove complete fuel line holder.
Remove throttle actuator.
Caution!
The work step Removing and installing throttle actuator
describes important instructions on installing the pull rods and
throttles.
Remove idling speed control valve. Remove molded hoses from
supplementary air distributor to tank venting valve and throttles.
Remove knock sensor cable guide from return line (cylinder
bank 5 to 8).
Disconnect vacuum hose for pressure regulator.
Disconnect vacuum hoses to solenoid-operated valve.
Remove heating feed line from engine block and from both return
lines on cylinder heads.
Remove coolant thermostat.
Installation:
Replace O-rings (1).
RA Removing and installing both cylinder heads (S62)
BMW AG - TIS
21.02.2013 06:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -