5 Series E39 M5 (S62) SAL
Coat joint between engine block and timing case cover with
Drei Bond 1209 (refer to BMW Parts Service).
Check dowel sleeves for damage and correct installation position.
Install new cylinder head seals.
Install cylinder heads. Install new cylinder head bolts. Do not wash
off screw coating.
Note:
To tighten down cylinder head bolts: Use special tool 11 2 250 .
At narrow points, use a socket with 3/8" drive.
Use special tool 00 9 120 for torsion angle tightening.
Tighten down cylinder head bolts on both cylinder heads in
sequence 1 to 10.
Tightening torque, 11 12 8AZ .
RA Removing and installing both cylinder heads (S62)
BMW AG - TIS
21.02.2013 06:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 16 -