5 Series E39 M5 (S62) SAL
Check camshaft adjustment.
Note:
Groove on 1st bearing cap is a little wider than groove in
camshaft.
Groove on inlet and exhaust camshafts must be located
inside groove on 1st bearing cap.
If necessary, adjust camshaft timing.
Remove special tool 11 7 130 from VANOS adjustment unit.
Replace sealing rings.
Attach oil line to VANOS adjustment unit.
Tightening torque, refer to 11 36 9AZ.
Assemble engine.
Caution!
There is air in the VANOS system once it is opened.
In the first few seconds after startup this results in a clearly
discernible "rattling noise".
This rattling noise does "not" indicate incorrect assembly.
The rattling noise will disappear as soon as the oil pressure
has built up and the system has vented.
RA Removing and installing/replacing toothed shafts of VANOS gear on right (S62)
BMW AG - TIS
21.02.2013 15:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 13 -