5 Series E39 M5 (S62) SAL
Installation:
Installation of camshafts and the VANOS adjustment unit is
described separately from removal. The assembly sequence for
installation and removal is different.
Note:
Signal rings of inlet and exhaust camshafts are different.
1)
Signal ring of inlet camshaft with one dowel pin
2)
Signal ring of exhaust camshaft with two dowel pins
Fit signal rings, align bores (1 and 2).
Install banjo bolt (1) and tighten down.
Tightening torque, refer to 11 31 13AZ .
Note:
Clean dirty parts.
Oil following parts before installation:
-
Camshaft contact face in cylinder head
-
Bucket tappets
-
Camshafts
-
Bearing caps
RA Replacing left camshafts (S62)
BMW AG - TIS
21.02.2013 07:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
