5 Series E39 M5 (S62) SAL
11 61 050
Removing and installing intake air manifold
(S62)
Remove intake filter housing upper section with air-mass flow
sensor.
E39 only:
Instructions apply to removing and installing both air ducts on left
and right.
Release retaining clips (1).
Caution!
The air ducts can brake at the firewall if not carefully removed
and installed.
Carefully turn air duct (2) upwards so that it is no longer locked in
firewall. Pull air duct (2) forwards and lift out.
The following work steps are shown on the E39. The same
procedure applies to the E52 (Z8).
Note:
A bracket for cable duct is screwed down with nut (1).
1.
Release outer nuts
2.
Release nuts (2)
Installation:
1.
Install all nuts
2.
Tighten down nuts (2) to approx. 5 Nm
3.
Tighten down remaining nuts to approx. 5 Nm
4.
Tighten all nuts to approx. 10 Nm
Note:
The funnels (1) for cylinders 2/3/4/6/7/8 are identical parts.
The funnels (2 and 3) for cylinders 1 and 5 are different.
Release nuts and remove funnels (1 to 3).
Installation:
Replace nuts.
RA Removing and installing intake air manifold (S62)
BMW AG - TIS
21.02.2013 15:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
