5 Series E39 M5 (S62) SAL
Note:
Remove the sealing flange so that it is possible to measure
the full throttle opening (when setting the full load adaptation
stop) with a standard slide caliper.
Remove and install sealing flange for left intake air manifold,
refer to 11 61 056.
Prepare special tool kit 13 0 150:
Insert extension pin (1) into dial gauges.
Position dial gauge plates on throttle body of cylinders 2 and 3 and
throttle body of cylinders 6 and 7. Mount dial gauges with
inserted extension pins in dial gauge plate supports for measuring
at throttle bodies 3 and 6.
If necessary, press pull rods off ball heads on servomotor side.
Note:
To simplify synchronization, correct height of dial gauges in
such a way that large needles point upwards.
Turn dials on both dial gauges so that large needles point to
zero.
Gently open and close each throttle bank several times to
check if the large needles are always pointing to zero.
If necessary, correct dials.
RA Removing and installing/replacing throttle actuator (S62)
BMW AG - TIS
21.02.2013 16:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
