5 Series E39 M5 (S62) SAL
Note:
Because of the closing force of the return spring in the
servomotor, one or both dial gauge(s) can display a slight
deviation from zero (approx. 0.01 mm). Do not correct gauge
dials.
Connect servomotor to engine wiring harness.
Activate servomotor by means of DIS Tester or MoDiC to specified
value 1 %.
Caution!
Do not open throttles by hand.
Servomotor shaft with twin lever would thus receive a different
radial position. This would result in an incorrect measurement
result and incorrect throttle setting.
When the servomotor is activated at 1 %, throttles 3 and 6 are
opened to such an extent that the dial gauges indicate a change
between 0.2 mm and 0.4 mm. Check whether both dial gauges
indicate the same value.
If necessary, turn hexagon head (1) on adjustable pull rod slightly
until both dial gauges indicate the same opening value for
throttles 3 and 6.
Enter specified value of 0 % and re-enter specified value of 1 %.
Check whether both dial gauges indicate the same opening value
for throttles 3 and 6.
Deviation between both dial gauges must be less than 0.03 mm.
Adjusting full-load adaptation stop:
Activate servomotor until throttles are fully open and stop
screw (1) rests against stop lug.
RA Removing and installing/replacing throttle actuator (S62)
BMW AG - TIS
21.02.2013 16:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
