5 Series E39 M5 (S62) SAL
Disconnect plug connections on ignition coils. This task is
described in the section "Replacing ignition coils".
Remove underbody protection at front and rear.
E39 only:
Remove cable holders (1).
Disconnect plug connection for exhaust temperature sensor on
left.
Note:
The exhaust temperature sensor is discontinued from September
2000. For details on how to proceed, refer to:
Discontinuation of exhaust temperature sensor
Remove cable holder (2).
Disconnect plug connection for oxygen and monitor sensors on
left and right.
E52 only:
Mark left and right plug connections (1 and 2) to avoid mixing up
plugs.
Unclip left and right plug connections (1 and 2) from holders and
disconnect.
Unclip cables from cable holders (3).
Note:
The exhaust temperature sensor is discontinued from September
2000. For details on how to proceed, refer to:
Discontinuation of exhaust temperature sensor
Disconnect plug connection (1).
Unclip cable (2) from cable holders (3).
RA Replacing wiring harness section for engine (S62)
BMW AG - TIS
21.02.2013 16:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
