5 Series E39 M5 (S62) SAL
Remove heat shield and positive cable from front axle support.
Unfasten bracket of oil cooler line (steering unit) on front axle
support.
Unfasten wheel arch trim from front area of front axle support.
Remove steering gear from front axle support (lines remain
connected).
Installation:
Replace self-locking nuts.
Draw in steering gear on screw (1) until it abuts the front axle
support and only tighten hand-tight. First tighten screws (2),
then tighten screw (1).
Tightening Torque,
refer to Technical Data 32 00 1AZ.
Unscrew left and right nuts.
Remove screw (1) and turn steering onto lock if necessary.
Installation:
Replace self-locking nuts.
Tightening Torque,
refer to Technical Data 31 12 13AZ.
Unfasten stabilizer mount on front axle support.
Installation:
Wet retaining bracket with low-surface-tension water.
RA Removing and installing/replacing front stabilizer (high)
BMW AG - TIS
21.02.2013 21:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
