5 Series E60 520d (N47) SAL
Important!
After the engine has stopped, wait at least 1 minute before
releasing the high-pressure lines.
After disconnecting the pressure line, it is absolutely essential
to seal the openings in the high-pressure pump and the high-
pressure accumulator with protective caps.
Recycling:
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
Release union nuts (1) on pressure line with special tool
37 1 152 .
Reset special tool in good time in order to avoid bending high-
pressure lines.
Tightening torque 13 53 2AZ
.
Remove rubber mount (2).
Installation:
Pay attention to installation position of rubber mount and
abrasion protection on pressure line.
RA Replacing pressure line (between high-pressure pump and pressure accumulator) (N
BMW AG - TIS
23.01.2013 17:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -