5 Series E60 520d (N47) SAL
Cleaning injector slots:
Copper sealing ring must not remain in injector slot.
Insert sealing cap 13 5 215 with fitting rod 13 5 214 in injector
slot. Remove fitting rod.
Insert cleaning tool with brush head 13 5 210 in injector slot.
Using turning movements, move brush head up and down in
injector slot with a suitable tool (8 WAF). Blow out injector slot with
compressed air after removing cleaning tool.
Important!
Wear protective goggles and cover injector slot with cleaning
cloth or similar.
Remove sealing plug 13 5 215 with fitting rod 13 5 214 again.
Note:
Replace copper sealing ring (1) on injector (2) without fail.
Installation:
Lightly lubricate injectors with highly heat-resistant grease before
installing in injector slot (above copper sealing ring up to injector
slot end).
(BMW part number 83 23 0 441 070)
Observe installation position of high-pressure connection.
RA Removing and installing/replacing all injectors in fuel injection system (N47)
BMW AG - TIS
23.01.2013 17:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
