5 Series E60 520d (N47) SAL
36 13
Subsequent installation of wheel-bolt lock
Loosen wheel bolts.
Raise car so that wheel can be turned freely.
Release wheel studs to such an extent that the wheel can move
freely on the wheel hub.
Turn wheel so that valve is face down.
Remove top wheel stud and insert wheel stud lock.
Possible play in wheel centre and wheel weight could cause
imbalance.
This imbalance is reduced to a minimum by installing the
somewhat heavier wheel-bolt lock in the top wheel-bolt position.
In this position - wheel stud lock at top, valve at bottom - tighten
wheel studs hand-tight in diagonal sequence.
Lower car and tighten wheel bolts crosswise.
Tightening torque 36 10 1AZ
.
RA Subsequent installation of wheel-bolt lock
BMW AG - TIS
23.01.2013 20:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -