5 Series E60 523Li (N52) SAL
Tightening torque 33 32 20AZ
.
Release nut and pull out bolt towards rear.
Installation:
Replace self-locking nut.
Tighten bolt connection in normal position.
Tightening torque 33 32 20AZ
.
Unfasten nut.
Remove screw towards rear and remove swinging arm.
Installation:
Replace self-locking nut.
Tightening torque 33 32 22AZ
.
After installation:
•
Check that output shaft is correctly seated in rear differential.
•
Perform chassis alignment check
RA Removing and installing/replacing left or right swinging arm
BMW AG - TIS
05.02.2013 22:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -