5 Series E60 523Li (N52K) SAL
12 61 280
Removing and installing/replacing oil
pressure sensor (N52, N52K, N51, N54, N53)
Necessary preliminary tasks:
•
Switch off ignition
•
N52, N52K, N51, N53 only:
-
Remove ignition coil cover
•
N54 only:
-
Remove intake filter housing
Warning!
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location:
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced; have
a cleaning cloth ready.
Unlock plug (1) and remove.
Release oil pressure sensor (2).
Tightening torque 12 61 1AZ
.
Installation:
Check engine oil level, top up engine oil if necessary.
RA Removing and installing/replacing oil pressure sensor (N52, N52K, N51, N54, N53)
BMW AG - TIS
08.02.2013 05:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
