5 Series E60 525i (N52K) SAL
41 11 023
Replacing front section of engine support to
left wheel arch
Read contents of Body, General.
For stripping and rigging operations, refer to texts on KSD
CD (FR number 41 11 023).
The reduced-weight aluminum front end structure (GRAV) is used
on this vehicle.
Observe specific procedure.
Place vehicle on straightening bench.
Following new body parts are required (refer to EPC):
-
(1) Wheel arch, front
-
(2) Support carrier, bulkhead, outer
-
(3) Engine carrier, front
-
(4) Reinforcement bracket, front, spring support
-
(5) Reinforcement bracket, rear, spring support
The engine carrier is supplied with longer bolts for the E60 and
E61. The bolts do not have to be shortened.
Open rivet joints in areas (1) to (3).
Installation:
Use 3 rivets (size 13) in area (1).
Use 2 rivets (size 13) in area (4).
Use 3 rivets (size 13) in area (3).
Note:
Engine carrier has been blanked out for purposes of clarity.
Spot-drill rivets in areas (1) and (2) from protruding rear side or
grind and punch through.
Installation:
Use 5 rivets (size 13) in areas (1).
Use 2 rivets (size 13) in areas (1).
RA Replacing front section of engine support to left wheel arch
BMW AG - TIS
17.02.2013 18:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -