5 Series E60 530i (N52K) SAL
Release screw (1).
Remove exhaust system bracket (2).
Tightening torque 23 71 4AZ
.
Release screws.
Remove transmission bearing block (1).
Tightening torque 23 71 4AZ
.
•
Support engine.
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Lift off retainer (1).
Disconnect shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
RA Removing and installing transmission (GS6-37BZ) N53/N52K
BMW AG - TIS
21.02.2013 16:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -