5 Series E60 530i (N52K) SAL
Remove suction filter housing.
Version with active front steering: Disconnect plug
connection (1).
Release screw (2).
Installation:
Replace aluminium screws.
Observe screwing sequence.
Release bolts (1).
Remove power steering pump (2) downwards (in automatic
transmission upwards).
Installation:
Replace aluminium screws.
Observe screwing sequence.
Screw-fastening sequence:
1.
Secure power steering pump with screws
2.
Tighten side screw to 2 Nm
3.
Tighten front screws to 2 Nm
4.
Tighten down front screws to jointing torque and angle of
rotation
Tightening torque 32 41 1AZ
.
5.
Release screw at side and check screw fastening point for
gap freedom
6.
Tighten down side screw to jointing torque and angle of
rotation
Tightening torque 32 41 1AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing power steering pump for power steering gear with Dynamic
BMW AG - TIS
21.02.2013 18:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -