5 Series E60 530i (N53) SAL
Rotate intake camshaft (1) at cylinder No. 1 into position (2).
Installation:
Lower and upper bearing banks must be aligned to each other at
ground surfaces (1 and 2).
Bring thrust piece and legs of special tool 11 8 553 into contact
at milled surfaces.
Note:
Schematic depiction of special tool 11 8 553 at lower bearing
bank (2) and upper bearing bank (1).
Important!
Tighten screw (3) on thrust piece to 2 Nm.
Position special tool 11 8 553 over screw connection of bearing
banks.
Make sure that legs come into exact contact on ground surfaces,
lower bearing bank (1) and upper bearing bank (2).
RA Removing and installing or replacing intake camshaft (N53)
BMW AG - TIS
21.02.2013 14:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -