5 Series E60 530i (N53) SAL
Warning!
Wear full face guard and protective gloves.
Fuel can emerge spontaneously at high velocity from the fuel
injectors!
To reduce the fuel pressure, place rag over fuel injector and
carefully tap against the fuel injector with a spanner.
There is a risk of injury if the fuel pressure is not reduced!
Close off injector with protective cap (1).
Protective caps are available from BMW Parts Service.
Seal high-pressure rail with a matching plug from special tool kit
32 1 270 .
Seal pressure line (1) with a matching plug from special tool kit
32 1 270 .
Installing pressure line:
Installation of pressure rail is described separately from removal.
Same procedure for all pressure lines.
Copper seals that may be fitted (1) are no longer needed and
must be removed.
If reusing pressure line, lightly grease thread. New pressure lines
are already coated.
RA Removing and installing or replacing a high-pressure line (N54, N53)
BMW AG - TIS
21.02.2013 15:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -