5 Series E60 530i (N53) SAL
Release cable tie (2).
Disconnect plug connection on drive (1).
Raise power window unit and remove past lower screwing points
downwards completely.
Installation:
Make sure that power window rails are parallel, readjusting if
necessary.
When installing power window unit, replace anti-rattle protector
(foam pad) between power window motor and protective mat if
necessary.
Replacement:
Make sure that spindle protection tubes at top are sealed with
plugs (1).
Note:
The power window unit must be normalized after it has been
installed.
Operating sequence for normalization:
•
Open corresponding window completely.
•
Operate corresponding power window switch in "Close"
position (second switch stage).
•
Once the upper end position has been reached, hold power
window switch in position for approx. 500 secs. longer.
•
Check function.
Important!
Power windows have no anti-trapping mechanism. There is no
"Close" one-touch function or "Close" comfort function in the
Security version.
RA Removing and installing/replacing power window unit in left or right front door
BMW AG - TIS
21.02.2013 23:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
