5 Series E60 530Li (N52) SAL
31 11 001
Replacing front axle carrier
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Draw off and dispose off hydraulic fluid from fluid reservoir
•
Secure engine in installation position
•
Remove front wheels
•
Remove stabilizer
•
Disconnect pressure line(s) from vane pump
•
Disconnect return line from power steering cooler
•
Remove both tension struts from front axle carrier
•
Remove jointed rod of ride-height sensor from control arm
•
Remove both control arms from front axle carrier
•
Remove both tie rod ends from swivel bearing
•
Lower front axle support
Version with Dynamic Drive:
Remove pressure lines for oscillating motor of front axle with
hose/pipe holders.
Remove vent hose with filter.
RA Replacing front axle carrier
BMW AG - TIS
21.02.2013 19:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -