5 Series E60 530Li (N52) SAL
33 41 151
Replacing left or right wheel bearing on rear
axle shaft
Necessary preliminary tasks:
•
Remove drive flange for rear axle shaft
•
Detach wheel bearing inner race from drive flange
If necessary, raise wheel carrier slightly with workshop jack.
Release screws with 3/8 Torx socket.
Tightening torque 33 41 2AZ
.
Remove wheel bearing.
Installation:
Keep contact surface (2) of wheel bearing/wheel carrier clean
and free from oil and grease.
Except when replacing: Recondition tapped holes (1).
Install new wheel bearing.
After installation:
•
Adjust handbrake
RA Replacing left or right wheel bearing on rear axle shaft
BMW AG - TIS
21.02.2013 20:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -