5 Series E60 530Li (N52) SAL
Removal of power window:
1.
Feed out rear window lift rail
2.
Feed out front window lift rail
Replacement:
Release screws (1) and detach flat motor (2).
Tightening torque 51 33 1AZ
.
Note:
To activate the anti-trapping mechanism, a normalization must be
carried out after the power window unit has been installed.
Operating sequence for normalization:
•
Open corresponding window completely.
•
Operate corresponding power window switch in "Close"
position (second switch stage).
•
Once the upper end position has been reached, hold power
window switch in position for approx. 500 secs. longer.
•
Carry out function check (one-touch function, anti-trapping
protection and, if necessary, comfort function).
RA Removing and installing (replacing) power window unit in left or right front doo
BMW AG - TIS
22.02.2013 01:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -