5 Series E60 530Li (N52) SAL
61 31 006
Removing and installing/replacing fixture for
steering column stalk (from 09/2005)
Warning!
Move wheels into straight-ahead position and do not alter this
position during the repair work.
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Comply with notes and instructions on handling optical
waveguides.
Necessary preliminary tasks:
•
Remove steering wheel
•
Remove front section of steering column trim
•
Remove lower section of steering column trim
•
Remove top section of steering column casing.
•
If necessary, remove deformation element for steering
column trim.
Disconnect plug connections from rear on fixture for steering
column stalk (2).
Release screws (1).
Remove fixture for steering column switch (2) in direction of
arrow.
Installation:
Carry out steering angle sensor adjustment.
On vehicles with active front steering, steering angle sensor
adjustment is performed by means of initial operation / adjustment
of active front steering.
RA Removing and installing/replacing fixture for steering column stalk (from 09/200
BMW AG - TIS
22.02.2013 05:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -