5 Series E60 530Li (N52) SAL
66 31 001
Adjusting ACC sensor
Special tools required:
•
36 1 100
•
36 1 130
Important!
Check ease of movement of adjustment screws prior to
adjustment.
Pull-off torque of adjustment screws must not exceed 4 Nm!
Cover the lens to prevent it from coming into contact with rust
remover.
Spray adjustment screws with rust remover, then repeat
check after rust remover has taken effect.
If the pull-off torque is greater than 4 Nm, observe
instructions on replacing adjustment screws.
Lever out cap (1).
Carry out adjustment of ACC sensor (2) with special tool
36 1 130 by means of adjusting screws (3).
Special tool required:
Active Cruise Control ACC adjusting device, complete.
Order number: 81 10 0 021 292
Consisting of:
1.
Mirror, complete
2.
Wheel laser
3.
Slotted diaphragm
4.
Control bracket (for initial installation of rail)
5.
Rail
6.
Setup and Owner's Handbook (not shown)
RA Adjusting ACC sensor
BMW AG - TIS
22.02.2013 08:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -