5 Series E60 530Li (N52) SAL
86 10 ...
Repair work on GFP components with
Gelcoat surface
Scratches in Gelcoat surface
Scratches in the Gelcoat surface which do not allow the GFP mat
structure to show through can be touched up. Sand out scratches
with water and 800 wet sandpaper. Then sand with water and
2000 wet sandpaper. Prepare repair area for polishing (refer to
Original BMW Painting Handbook Chapter 8).
Cracks in Gelcoat surface
Sand the cracked area in a V shape beyond the end of the crack
and clean.
There must be no grease or oil residues, moisture or dust
remaining in the crack to be repaired.
When repairing holes such as e.g. rivet holes, deburr hole edge
and heavily roughen large area around hole.
Prepare required amount of Gelcoat paste with 2% hardener and
fill prepared repair area with spatula.
Apply Gelcoat paste in several applications to repair areas.
Adhere to mixture ratio (2 parts hardener to 100 parts Gelcoat
paste) as precisely as possible.
Too much added hardener slows down the hardening time and
changes the paint color.
The hardening period is at least 12 hours at 20
°
C room
temperature.
The hardening period can be longer depending on the
temperature.
Once the Gelcoat paste has hardened, sand the touched-up area
with water and 800 wet sandpaper. Sand with water and 2000 wet
sandpaper and prepare for polishing.
RA Repair work on GFP components with Gelcoat surface
BMW AG - TIS
22.02.2013 10:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -