5 Series E60 530Li (N52) SAL
•
Both front power windows
•
Both rear power windows after a delay
•
Sliding/tilting sunroof after a time delay
Convenience closing is performed in the following order:
•
Both rear power windows
•
Both front power windows after a delay
•
Sliding/tilting sunroof after a delay
The convenience function is stopped if the command is interrupted.
Emergency closing and panic mode
Emergency closing:
Emergency closing is for intentional closing of the side windows with the anti-trap function. To do this, the power
window switch must be pressed and held. It may be necessary to use this function in the event of an attack from
outside or if the side windows are frozen.
Emergency closing can be activated up to a speed of 16 km/h.
If something becomes trapped in the window, the selected side window opens just a few millimetres (unlike the
normal procedure when something is trapped in the window; see indirect anti-trap function).
Panic mode:
The panic mode can only be triggered after emergency closing has been performed.
If the user releases and then presses and holds the power window switch within 4 seconds, the side window is
closed without the anti-trap function. The side window is then closed with maximum force and speed. If
something becomes trapped, the power window motor runs until the overheating protection cuts in.
It is always possible to open the side windows irrespective of overheating protection.
Releasing the held power window switch interrupts the emergency closing or panic mode function.
When the childproof locks are applied, emergency closing for the rear side doors can only be triggered via the
switch block in the driver's door.
If emergency closing is triggered for any side window via the switch block in the driver's door: the closing
operation can be stopped by the other power window switches unless the childproof locks have been applied.
Childproof locks
The childproof locks inhibit the function of the rear power window switch. The childproof locks are
enabled/disabled through a switch on the switch block in the driver's door.
When the childproof locks are enabled, the function LED in the button is switched on.
No opening or closing is triggered when the childproof locks are enabled. Any opening or closing function that is
currently in progress (e.g. one-touch closing) is interrupted.
The childproof locks are deactivated in crash mode.
Safety functions with the childproof locks enabled and automatic closing function of the rear power windows in
progress:
•
The closing operation can be stopped by the relevant local power window switch.
•
The childproof locks can only be disabled if the key is engaged in the ignition lock.
Anti-repeat circuit
An anti-repeat circuit is provided for each motor to prevent the power window motors from overheating. The
running time for the power window motor is limited. The motor is switched off for a defined time.
SBT Power windows E60, E61, E63, E64
BMW AG - TIS
22.02.2013 19:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -