5 Series E60 530xi (N52) SAL
32 13 060
Removing and installing/replacing power
steering gear (AWD)
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Secure engine in installation position
•
Remove both tie rod ends from swivel bearing
•
Replacement only: Remove both tie rod ends from tie rod
•
Remove both control arms from swivel bearing
•
Remove both stabilizer links from stabilizer
•
Lower front axle carrier until power steering gear rests on
output shaft
Important!
Replacement only:
Banjo bolt (A) for pressure line (expansion hose) must be
replaced by banjo bolt with non-return valve (B).
RA Removing and installing/replacing power steering gear (AWD)
BMW AG - TIS
22.02.2013 02:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
