5 Series E60 545i (N62) SAL
Installation:
Clean seal residue from sealing surfaces.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Replace sealing elements (1).
Installation:
Make sure gasket is correctly seated at sides and on rear side of
cylinder head.
Installation:
Screw connections (1, 2, 3 and 4) of cylinder head cover are
different.
Replace screw connections (3).
Move cylinder head cover with gasket into assembly position.
Secure cylinder head cover, starting with screw connection (4)
from front.
Tighten down screw connections (1, 2 and 3) in diagonal
sequence from inside to outside.
RA Removing and installing/sealing right cylinder head cover (N62/N62TU)
BMW AG - TIS
22.02.2013 11:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
