5 Series E60 545i (N62) SAL
Clamp special tool 11 9 470 as illustrated in a vice.
Important!
Do not tilt bearing bracket (1).
Carefully lift out bearing bracket (1).
Place bearing bracket (1) with inlet camshaft and eccentric shaft
as illustrated on special tool 11 9 470 .
Secure bearing bracket (1) with a nut (special tool 11 9 473 ).
Important!
The lower section of the bearing bracket (1) is machined with
the cylinder head and must not be mixed up.
Note:
Lower section of bearing bracket (1) remains on cylinder head.
RA Removing and installing/replacing right intermediate levers (N62 from 9/03 and N
BMW AG - TIS
22.02.2013 12:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -