5 Series E60 545i (N62) SAL
Note:
Position of exhaust adjustment unit (2) to timing chain can be
freely selected.
Pull timing chain up.
Feed exhaust adjustment unit (2) into timing chain and fit onto
exhaust camshaft.
Replace screw.
Install screw on exhaust adjustment unit.
Tighten screw without play and then slacken off again by half a
turn.
Note:
Position of inlet adjustment unit (1) to timing chain can be freely
selected.
Pull timing chain up.
Feed inlet adjustment unit (1) into timing chain.
Press tensioner rail (3) back and fit inlet adjustment unit (1) onto
inlet camshaft.
Note:
If tensioner rail (3) cannot be pressed back far enough to enable
fitting of inlet adjustment unit (1):
Slacken off chain tensioner by approx. three turns.
Fit inlet adjustment unit (1).
Replace and insert screw on inlet adjustment unit (1).
Tighten down chain tensioner.
Tightening torque of chain tensioner, 11 31 8AZ
.
RA Removing and installing/replacing inlet and exhaust adjustment units on right si
BMW AG - TIS
22.02.2013 12:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -