5 Series E60 545i (N62) SAL
51 47 000
Removing and installing/replacing front
(inside) left or right entrance cover strip
Disengage retaining lugs (5) of front entrance cover strip (2)
from both adjoining panels.
Important!
Carefully lever out front entrance cover strip (2).
Lever out front entrance cover strip (2) at front retaining
points (3).
Pull back front entrance cover strip (2) and feed out of rear
retaining points (1).
Installation:
Position front entrance cover strip (2) preinstalled with clips (4)
on associated bores and clip into place.
Installation:
Rails of front entrance cover strip (2) must not be damaged.
Retaining lugs (3) of front entrance cover strip (2) must not be
damaged.
If necessary, lever out remaining clips (1) in floor panel.
If necessary, replace faulty clips (1).
Slide clips (1) into rails of front entrance cover strip (2).
RA Removing and installing/replacing front (inside) left or right entrance cover st
BMW AG - TIS
22.02.2013 23:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -