5 Series E60 550i (N62TU) SAL
Cold cementing:
- BMW 83 19 0 147 369
Adhesive cartridge:
- BMW 83 19 0 152 031
a)
Clean with spirit (available in pharmacies).
b)
Observe an air drying time of at least 1 minute
c)
Apply a thin coating of "Glass Activator 1"
d)
Observe an air drying time of at least 10 minutes
Version with inspection window for vehicle identification number in windscreen only (all except US/GB):
-
Seal inspection window (bottom left) with Sika primer 206 G+P
Adhesive quantities:
Approx. 1 1/4 adhesive cartridges are needed to cement Security Series windows.
Important!
If a second cartridge is required for cementing:
Bubbling results in leakage and insufficient bonding strength (torsional rigidity, passenger airbag).
Effect of differing adhesive quantities:
Too little adhesive:
Too much adhesive:
-
Windscreen rests too low in body cutout
-
Strains/tensions may occur (windscreen breakage)
-
Insufficient squeezing of adhesive bead (leaking)
-
Windscreen rests too high in body cutout
-
Wind noise may occur
-
Strains/tensions may occur (windscreen breakage)
-
Fouling of add-on parts by emerging adhesive
Spacer buffers:
Before sticking on new spacer buffers, remove all remaining traces of existing spacer buffers completely.
Position of spacer buffers must be observed exactly.
Incorrectly fitted spacer buffers will result in:
-
Windscreen glass breakage
-
Wind noises
Assembly:
To prevent a pressure increase in the vehicle interior when the doors are closed:
-
Open a window
Important!
After the adhesive bead has been applied, the window glass must be fitted within 5 to 10 minutes
(depending on air humidity, temperature and use of accelerator).
After 5 to 10 minutes the adhesive bead forms a skin which can no longer guarantee a perfect bond.
The glass will slip down if other adhesive tapes are used.
RA Instructions for window cementing (Security)
BMW AG - TIS
22.02.2013 22:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
