5 Series E60 M5 (S85) SAL
Installation:
All bearing shells are assigned to one cylinder.
E and A from (1 to 10), e.g. E 6= inlet side on 6th cylinder.
Arrow (1) must point in direction of travel to chain drive.
Installation:
Arrangement of bearing shells, cylinders 6 to 10.
Important!
Mixing them up will result in increased wear - risk of damage!
Mount special tool 11 5 241 with special tool 11 5 242 .
Pretension eccentric shaft (1) at hexagon head in direction of
arrow.
Important!
Inlet camshaft is pressed upwards by valve springs.
Lock must snap audibly into place.
Install all bearing caps by numbers.
Tightening torque: 11 31 7AZ
.
Adjust valve timing.
Assemble engine.
RA Removing and installing or replacing left inlet camshafts (S85)
BMW AG - TIS
22.02.2013 16:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
