5 Series E60 M5 (S85) SAL
Release screws (1).
Tightening torque: 11 31 7AZ
.
E
Inlet camshaft.
A
Exhaust camshaft.
Important!
Risk of mix-up with cylinder bank 6-10.
Arrow must point in direction of travel to chain drive.
Installation:
Lubricate all bearing points with engine oil.
Release screws along lines (1).
Tightening torque: 11 31 7AZ
.
Note:
Illustration does not show special tool 11 5 241 .
Release lock on special tool 11 5 241 .
Relieve tension on eccentric shaft (1) at hexagon head in
direction of arrow.
Inlet camshaft is pressed upwards by valve springs.
Important!
Inlet camshaft must lift off uniformly in upward direction.
Remove special tools 11 5 241 and 11 5 242 .
Remove inlet camshaft.
Insert inlet camshaft, cylinders 1-5.
Designation (E1) on dihedron points upwards.
Cams (1) point sideways to exhaust side.
Installation:
Lubricate all bearing points with engine oil.
RA Removing and installing / replacing right inlet camshaft (S85)
BMW AG - TIS
22.02.2013 16:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
