5 Series E60 M5 (S85) SAL
Gap between stop screw (1) and actuator (2) of throttle valve
must be less than 0.05 mm.
To check gap, use a feeler gauge with a thickness of 0.05 mm.
Checking gap:
-
Pull pull rod of throttle valve actuator in opening direction of
throttle valves.
-
Slide feeler gauge (3) between stop screw (1) and
actuator (2) of throttle valve.
-
Return throttle valves slowly to stops.
When correctly adjusted, feeler gauge will jam between stop
screw (1) and actuator (2) of throttle valve.
Perform check on each throttle valve assembly.
Performing throttle valve basic setting:
A basic setting must be performed if the gap is larger than
0.05 mm at one or more throttle valve assemblies.
Note:
In order to ensure correct throttle valve setting, you must slacken
all the screw connections on the actuating levers with the
actuating shaft except at throttle valve assemblies 5 and 6.
(Replace nuts).
It is not possible to set the throttle valve at throttle valve
assemblies 5 and 6.
However, if increased play is ascertained, the corresponding
cylinder bank must be reset.
The actuating levers of throttle valve assemblies 5 and 6 are
connected to the actuating shaft via fitting screws and fitting
bores.
Do not slacken the screw connections of the actuating levers for
the long pull rods.
The long pull rods must not be disengaged from the actuating
levers for the setting procedure.
RA Performing throttle valve basic setting (S85)
BMW AG - TIS
22.02.2013 17:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
