5 Series E60 M5 (S85) SAL
Release screw.
Tightening torque 13 54 3AZ
.
Slide actuating shaft (1) in direction of arrow towards front and
turn through approx. 180
°
.
Release nuts (2) with special tool
34 3 171 .
Unlock plug (1) and remove.
Release wiring harness from retaining clip (2).
Release nut (3) and disconnect starter positive lead.
Tightening torque 12 52 2AZ
.
Unfasten nut.
Tightening torque 12 52 3AZ
.
Carefully raise cable duct (4) slightly and remove throttle valve
assembly (5).
Release screws and detach Hall sensor (1) from throttle valve
assembly.
Installation:
Make sure Hall sensor is installed in correct position.
Installation:
Clean sealing surface (1). Note correct position of adapter
sleeves (2).
RA Removing and installing/replacing right Hall sensor (S85)
BMW AG - TIS
22.02.2013 17:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -