5 Series E60 M5 (S85) SAL
23 42 519
Replacing pressure accumulator (GS7S47BG
SMG)
Important!
Before working on hydraulic system:
-
Reduce pressure in hydraulic system by means of
Service Function in DIS Tester (Replacement and
Repair)
-
Disconnect hydraulic pump relay in electronics box
Do not reconnect relay for entire duration of repair work
Important!
After working on hydraulic system:
-
Perform bleeding using DIS Tester, refer to Service
Functions in DIS Tester (Replacement and Repair)
Necessary preliminary tasks:
•
Unscrew and remove splash guard.
•
Remove reinforcement plate
Important notes on installation are described in this work step
•
Remove heat shields
Release screw (1).
Tightening torque 23 41 24AZ
.
Bend clamp (2) open slightly.
Release pressure accumulator (3) at hexagon head (5).
Remove pressure accumulator (3) with damping ring (4) towards
rear.
Tightening torque 23 41 25AZ
.
Installation:
Replace screw (1).
RA Replacing pressure accumulator (GS7S47BG SMG)
BMW AG - TIS
22.02.2013 19:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
