5 Series E60 M5 (S85) SAL
34 11 220
Removing and installing/replacing both front
brake discs (S85)
Necessary preliminary tasks:
•
Remove wheels
•
If necessary, remove and clean brake pads
After completing work, read and comply with notes on braking in
new brake discs / brake pads.
Important!
If the thickness of the brake discs drops below the minimum
brake disc thickness (MIN TH ), then the brake discs must be
replaced.
Brake discs may only be replaced in pairs (on each axle).
If the brake discs are replaced, you must also fit new brake
pads.
The brake discs of M models are tied to the direction of travel:
The uneven part number denotes the left brake disc, the even
part number the right brake disc!
Unfasten screws (1), remove brake caliper and fasten up.
Note:
Brake hose remains connected.
If the brake hose was pulled from the mounting fixture during
removal, make sure it is positively attached when installed!
Installation:
Tightening torque, 34 11 2AZ
.
Release screws (1) and remove brake disc (2).
Important!
To release brake disc: Do not under any circumstances strike
friction ring with a hammer or similar! If necessary, carefully
tap on base of brake disc chamber with a rubber mallet.
Installation:
Thoroughly clean contact surface of brake disc on wheel hub
and guide pins (3), remove traces of corrosion if necessary.
Brake disc can only be mounted in one position.
Replace screws.
RA Removing and installing/replacing both front brake discs (S85)
BMW AG - TIS
22.02.2013 21:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
