5 Series E60 M5 (S85) SAL
34 52 580
Removing and installing / replacing rear
pressure sensor for ACC
Note:
Read and comply with General Information.
After completing work: Bleed braking system
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Vehicles with N52 engine:
If necessary, remove heat shield (1).
Installation:
Make sure heat shield is correctly seated.
If necessary, replace heat shield.
Disconnect plug connection (1).
Release pressure sensor (2) and remove.
Installation:
Tightening torque 34 51 12AZ
.
RA Removing and installing / replacing rear pressure sensor for ACC
BMW AG - TIS
22.02.2013 21:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
